Austria Email PS100 insulated buffer tank for heating water 100 l
Austria Email PS100 insulated buffer tank for heating water 100 l

Austria Email PS100 insulated buffer tank for heating water 100 l

Height 884 mm, width 480 mm, depth 500 mm, complete with wall mounting frame and four feet for floor mounting
 Back: Fujitsu High Power - 25 ° C series

PS 100 price xxx eur + km (height 884 mm, width 480 mm, depth 500 mm, includes wall mounting frame and four feet for installation on the floor)

WPPS 130 price xxx eur + km

WPPS 200 price xxx eur + km

WPPS 300 price xxx eur + km

WPPS 400 price xxx eur + km

WPPS 500 price xxxx eur + km

or

or

or

It is recommended to install a buffer tank in the heating circuit connected to the heat pump. The buffer tank increases the water volume in the system and reduces the heat pump starts (the heat pump will run with better efficiency). The buffer tank is also a flow balancer for the heating circuits (the primary and secondary sides have different water flows).



The buffer tank also reduces the choking of the radiators. Clogging occurs when the heat pump switches from heating mode to domestic water production. Without a buffer tank, the changes in the heating water temperature (ups and downs) in the radiator circuit are large at this time. Rapid temperature changes cause the radiators to crack. 

For an On-Off heat pump, it is recommended to install a storage tank V = 20 x heat pump heat output [liters] on the heating circuit.

 

or

You will find a selection and prices: Austria Enamel storage tanks